Browse by Tags

Surround or Rear Surround, which to use?

I have an Onkyo tx-sr607 A/V Receiver and the Mirage Nano 5.1 system. My question is; my back speakers are located higher on the rear wall, not to the side of the main listening area, should I connect these speakers to the L & R "surround" binding posts or the L & R "rear"...

Posted to Technical Questions (Forum) by singlemalt65 on 08-12-2009
Matching a Non-Mirage Center-Channel w/Nanosats 5.1....???

I am fairly new to "home theater" and have a question in configuring my very first layout, I hope you provide some help. Can I "successfully" match up my Nanosats with a "B&W DM600 center-channel speaker" and turn my theater into a 6.1? My viewing room is relatively...

Posted to Technical Questions (Forum) by kateyandsarahsdad on 12-08-2008
s8 subwoofer humming

I'm using an S8 subwoofer fresh out the box and it's humming even without a speaker cable connected. Any tips on how to get rid of the hum or this a faulty unit?

Posted to Technical Questions (Forum) by englishman on 02-17-2008
Nano-sub noise problem?

I have two nano-subs one sub works perfectly and the other has problems occasionally. Both subs are plugged into the same power source on the conditioned side of a panamax power conditioner. The are both in auto power mode. One sub works perfectly. With the stereo off one sub will sometimes kick on where...

Posted to Powered Subwoofers (Forum) by CrashTestDummy on 01-16-2008
Nanosat crossover frequency settings

Hi, I have a basic question. I just recently bought a Nanosat 5.1 system. The manual suggests setting the bass management crossover setting to 120Hz. My question is that should I set the crossover setting to 120HZ for all 5 speakers or just for the subwoofer? Thanks for the help, david

Posted to Technical Questions (Forum) by bolero88 on 12-13-2007
Re: MS-STB Stands Don't Work With Nanostat?

Funny, I having exactly the same problem. I am running 12 gauge calbes through the ceiling which I cannot take out now so this is turning into a nightmare. I can get the cable through the hole but not feed it through. ANY IDEAD MIRAGE? Thanks Matthew

Posted to Technical Questions (Forum) by englishman on 11-27-2007
I purchased about a year ago e nanosat 5.1 system witch it came with a denon receiver. One of my speakers recently stopped working. I did some tests and finally the bigger speaker inside is blown of. Any idea where I can get this speaker. Thank you

Posted to Technical Questions (Forum) by djgerti on 11-05-2007
Nanosat Prestige

Hello all, I'm currently looking at a new setup in my new home that's pre-wired for surround sound. I am looking at the NanoSat Prestige satellite speakers...will I be able to use the existing "pre-installed" speaker wire? Thanks in advance -

Posted to Technical Questions (Forum) by 3fiddy on 10-16-2007

Page 1 of 1 (8 items)

Home Blogs Forums Photos	A Klipsch Group Company
© Klipsch Group, Inc. All Rights Reserved. Community Terms Of Service Unauthorized Dealer Warning

Browse by Tags

A Klipsch Group Company